Lastly, connect the jumper cable from the - power rail to GND so you have a closed electric circuit and your hardware is good to go :) Connect the last jumper cable to the - side of the power rail like the resistors.Ĭonnect the jumper cables of the buttons to the pins 2, 3, 4, 6, 8 from left to right as shown in the picture with the arduino and connect the jumper cable of the buzzer pointing towards the + and - both to pin 11 and 13 respectively. Attach 2 jumper cables to the buzzer: one towards the + side and one towards the -, both in row 29. Connect it to the other leg of the button on towards the + side of the breadboard. I used this video as a reference:Īttach a jumper cable to a button each.
#Tokyo ghoul unravel tabs update#
I didn't have enough time to do the whole opening, so it's only the first 30seconds, however, I will update this instructable until I got the whole opening song. The song in the video is Unravel from the popular anime Tokyo Ghoul. Which means that when you press it a song, which you can code, will play. It's too bad, but only one note can be played at the time. You can code whatever note you want and I chose from left to right the piano notes G4, A4, A#4 and C5. It's an easy project using the arduino program and it's pretty self-explanatory: you press one of the first four buttons and the buzzer will play a note. I immediately knew what I and my partner were going to do. When I was looking at random projects I saw a mini-piano arduino instructable and. I wanted to do something not too hard, but also something that's in my interest. So first off, I had to make an electric device for a school project.